A unit specified at "180% density" tells a knotter almost nothing about the hairline. Natural hair is sparsest at the front edge and thickest through the crown, and reproducing that gradient is what separates a unit that photographs well from one that reads as a wig in daylight.
1. The First Two Centimetres
The front edge should be ventilated at roughly half the body density, with single hairs rather than pairs and a slight irregularity along the line. This is the zone the eye reads first. Density added here to "make it look fuller" is the single most common reason a lace unit looks costumed.
2. The Transition Band
Between roughly two and five centimetres back, density should climb in steps rather than in one jump. Ventilating this band at three levels — light, medium, medium-full — gives the hairline a soft fall instead of a visible ridge where density changes.
3. Crown and Perimeter
The crown carries the highest density, and the side and back perimeters should sit slightly below it so the unit does not read as a helmet from behind. On a hand-tied base the knotter can vary density per zone; on a machine-wefted unit it cannot, which is the practical reason bespoke units photograph better at the back.
4. Write the Map, Not the Number
Specify density as a short table by zone — front edge, transition band, mid-length, crown, perimeter — and attach it to the order. A replacement unit built from that table will match; a replacement built from a single percentage will not.